Controllers for Fire Pumps and Jockey Pumps When there's a call to start a fire pump in an emergency situation, you need a fire pump controller that you can count on to start every time, without fail because life safety depends on it. We supply world class fire pump controllers and jockey pump controllers that are designed and manufactured in accordance with the strictest fire protection, electrical and insurance codes in the world, thereby ensuring they meet or exceed all required standards. We supply a wide range of controllers including the ones listed below, and we can service even more. Eaton Cutler Hammer fire pump controllers are microprocessor based and are available in both Electric and Diesel Engine models. Electric controllers are available as Full or Limited Service units, and can be supplied with an integral or stand alone Automatic Transfer Switch. Diesel Engine controllers are available with 120Vac or 220Vac supply and 12Vdc or 24Vdc output. Hubbell Fire pump Motor Controllers with Automatic Transfer Switches (ATS) are designed to comply with the latest standard of the National Fire Protection Association for the installation of stationary pumps for fire protection. Firetrol Fire Pump Controllers are factory assembled, wired, tested as a unit and confirmed to all requirements of the latest edition of NFPA-20 (Centrifugal Fire Pumps) and NFPA-70 (National Electrical Code). Firetrol controllers are listed by Underwriters Laboratories, Inc., in accordance with UL218, Standard for Fire Pump Controllers, CSA, Standard for Industrial Control Equipment (UL) and approved by Factory Mutual (FM). All Firetrol controllers are Y2K compliant. Metron Fire Pump Controllers use only the highest quality components all UL listed or UL recognized. The cabinet is fabricated of heavy gauge reinforced steel with drip-proof hood. All field wiring and service connections may be made from the front, allowing the controller to be mounted flush against a wall. The controller is completely wired, assembled, and tested at the factory before shipment, and ready for immediate installation. Joslyn Clark Controls, offers a complete line of Diesel and Electric Fire Pump Controllers. Life safety and fire protection for buildings and building content is our primary design consideration. Torna Tech You can choose from different lines of fire pump controllers built to latest NFPA 20 Standard depending on the market needs: UL, FM, ULC or NFPA non-approved, many fire pump accessory controllers, such as jockey pump, alarm panels and also industrial pump control panels. Master Controls have Variable Speed Electric Motor Drive Fire Pump Controllers and Transfer Switch Controllers with Soft Stop, Mode Switch, Line Side and Load Contactors Isolation Contactors, VFD Safety Fusing and 5% Line Reactor all standard. Our technicians can service all of the above controllers we supply above as well as controllers no longer available like AO. Smith, Westinghouse, Lexington and others.  Jockey Pump Controllers are a critical component and are intended for use with fire pump systems. They are used for pressure maintenance in fire pump system installations to prevent unnecessary cycling of the main fire pump. Jockey Pump Controllers are available in the following configurations:
We stock Jockey Pump Controllers! Model CTS-510 single phase, up to 3/4 hp. We also supply jockey pump controllers from all the other manufacturers identified above. Let us know what you need and we'll supply you with a solution. To speak with an Apex Controllers specialist call 866.563.2739.Apex Pumping Equipment - "We Supply Solutions!" |
Print This Page