Valves
APEX supplies a wide range of valve types and sizes from leading manufactures which meet all international regulations and standards. Some of the products we supply are listed below and in stock now. Give us a call and we can find what you need.
Circulation Relief Valves
Cash ACME .75" Circulation Relief Valves Small, low-cost relief valves suitable for static over-pressure protection. Calibrated adjusting screw for occasional changes in pressure setting without the use of a pressure gauge. Bronze bodies with male inlet and female outlet, silicone seat and stainless steel spring. Factory setting, 125 psi
 Kunkle/Tyco Circulation Relief Valves. All bronze, equipped with handwheel for easy adjustment. Along with male inlet and female outlet. Inlet and outlet connection integrally cast into body to permit easy inspection and servicing without disconnecting piping. Lapped beveled seats for optimum performance. Stainless steel spring for optimum corrosion resistance.
Cla-Val Circulation Relief ValvesUL listed/FM approved. Pressure relief valve is a direct-acting, spring loaded, diaphragm type relief valve. Pressure adjustment is simply a matter of turning the adjusting screw to vary the spring load on the diaphragm. To prevent tampering, the adjustment cap can be wire sealed by using the lock wire holes provided in the cap and cover.
Automatic Air Relief Valves
Val-Matic Automatic Air Relief Valves Suitable for clean or raw water service in fire protection applications with pressures up to 300 PSI. The body inlet connection shall be hexagonal for a wrench connection. The valve body provides a through flow area equal to the nominal valve size. A bolted cover with alloy screws and flat gasket provided to allow for maintenance and repair.
Ball Drip Valve
Valve unseats only by force of gravity causing ball to fall off seat. Use only in horizontal position. Do not use with more than one foot of head (water pressure) on ball check. This valves provides for a level of freeze protection when the main valve to isolate the hose valve header is leaking water by the ball drip will allow the water to drip out in the pump room rather then pressurizing the pipe and hose header and risking freeze up, and cracking on those cold winter days.
2.5" Valves with Cap & Chain
Female NPT inlet x male hose thread outlet, 300 PSI case brass construction, UL listed/FM approved. Use as fire house outlet connections. Or Female hose thread swivel inlet x male hose thread outlet, solid wedge disc with tapered seats, 300 PSI, cast brass, UL listed/FM approved. Use
To speak with a specialist about Valves call (866) 563-2739 or click here for additional information.
Apex Pumping Equipment - "We Supply Solutions!"
| 
